Laser range finder - 50cm (VL6180)
Summary
How to Connect
To connect to the Grove board:
Use female-to-female cables
Connect four wires to pins inside one of the I2C sockets on the central portion of the board (top right)
Connect left-most wire (GND) to GND pin on module
Connect the second-left wire (VCC) to VCC pin on module
Connect the second-right wire (SDA) to SDA pin on module
Connect the right-most wire (SCL) to SCL pin on module
How to Use
In XOD:
Test patch:
In Arduino IDE:
Notes
Technical Specs
Datasheet